Ti:sapphire ring laser produces 10-femtosecond pulses

April 1, 1996
Nearly bandwidth-limited, 10-fs pulses of 790-nm laser light have been produced by researchers at the Max Planck Institute (Munich, Germany) using a Ti:sapphire ring resonator. The pulse-shortening mechanism in a Ti:sapphire resonator is similar to soliton formation in optical fiber. An important difference for short pulses, though, is that in each element of the fiber, negative group-delay dispersion (GDD) and self-phase modulation (SPM) are simultaneously present. In a resonator, these act in

Ti:sapphire ring laser produces 10-femtosecond pulses

Nearly bandwidth-limited, 10-fs pulses of 790-nm laser light have been produced by researchers at the Max Planck Institute (Munich, Germany) using a Ti:sapphire ring resonator. The pulse-shortening mechanism in a Ti:sapphire resonator is similar to soliton formation in optical fiber. An important difference for short pulses, though, is that in each element of the fiber, negative group-delay dispersion (GDD) and self-phase modulation (SPM) are simultaneously present. In a resonator, these act in an alternating manner. However, in a ring resonator configuration, SPM and GDD are automatically distributed as homogeneously as possible. And, while previous ring cavities contained large amounts of optical material causing significant higher-order dispersion that limited laser performance, the Planck investigators had available very highly doped (absorption coefficient of 6.2 cm-1) Ti:sapphire crystals and chirped mirrors for intercavity dispersion control.

The mirrors compensated for the positive GDD from the laser crystal but only in coarse steps. Thus, thin plates of laser-grade fused quart¥were introduced into the laser cavity at less than Brewster`s angle to eliminate etalon effects, and fine tuning comparable to a prism-controlled reasonator was achieved. The researchers were able to run the reasonator down to zero GDD. Pulses as short as 10 fs were produced with a 1.1-mm-thick quart¥plate in the resonator.

Sponsored Recommendations

Advancing Neuroscience Using High-Precision 3D Printing

March 7, 2025
Learn how Cold Spring Harbor Laboratory Used High-Precision 3D Printing to Advance Neuroscience Research using 3D Printed Optical Drives.

From Prototyping to Production: How High-Precision 3D Printing is Reinventing Electronics Manufacturing

March 7, 2025
Learn how micro 3D printing is enabling miniaturization. As products get smaller the challenge to manufacture small parts increases.

Sputtered Thin-film Coatings

Feb. 27, 2025
Optical thin-film coatings can be deposited by a variety of methods. Learn about 2 traditional methods and a deposition process called sputtering.

What are Notch Filters?

Feb. 27, 2025
Notch filters are ideal for applications that require nearly complete rejection of a laser line while passing as much non-laser light as possible.

Voice your opinion!

To join the conversation, and become an exclusive member of Laser Focus World, create an account today!