Andrew Davidson

Senior Staff Engineer, MKS Newport - New Focus

[email protected]https://www.newport.com/b/new-focus

Andrew Davidson is a Senior Staff Engineer at MKS Newport - New Focus (Irvine, CA).

FIGURE 1. Devices for detecting the position of a laser beam include: a) a position-sensitive detector (PSD), b) a quadrant-cell detector (quad cell), and c) a CMOS camera. The X and Y beam position on both the PSD and quad cell can be calculated from the detectors’ current outputs iA, iB, iC, and iD. The beam position on the camera is determined by finding the beam’s centroid.

Home

DETECTORS: CMOS cameras allow robust active stabilization of laser beams

Andy Cordes

Aug. 1, 2011

Accurate measurement of the position of a laser beam can be achieved in several ways, each with its strengths and weaknesses. A comparison of these has resulted in an active beam...

FIGURE 1. The impulse response (blue) of a 4-GHz receiver was measured with a 1-ps, 1530-nm pulse on a 50-GHz oscilloscope. The step response (red) was then calculated by integrating the impulse response, which can be used to derive the eye diagram.

Detectors & Imaging

Photodetector impulse response yields eye-diagram information

Herman Chui

July 1, 2005

The eye diagram of a photoreceiver is a key ingredient in assessing performance of an optical-communications network.

Indium gallium arsenide detector, designed for use in the laboratory, has a 45-GHz bandwidth and operates at wavelengths from 950 to 1650 nm.

Detectors & Imaging

Demand for high-speed detectors drives research

Andrew Davidson

April 1, 1998

Resonant-cavity enhanced detectors improve detection and wavelength selectivity; high-power traveling-wave detectors increase dynamic range of analog fiber links.